Skip to Content Skip to Navigation

Amusement Device Detials

The New York State Department of Labor inspects all amusement devices on or before the scheduled start date of an event. Only those devices deemed safe are allowed to operate. Detailed inspection results for each individual device will be posted within two weeks of the event start date.

For more information, look at our Frequently Asked Questions.

Details for device: Tubs of fun

Violation Summary

Violations Issued This Season: 6 Violations Complied at Time of Inspection: 1
Tubs of fun Violations
Date Cited Description Violation
8/3/2017 DO NOT LOAD TUB #4, until the hub/bearing assembly is repaired or replaced.45-1.6(c)
45-1.6(c)Parts which are excessively worn or which have been materially damaged shall not be used. Close visual inspection of parts shall be made during assembly to discover such wear or damage and immediate inspection of fastening devices shall be made after assembly to assure that they have been properly installed.
8/13/2017 Install a second exit gate in the perimeter fence.45-2.11
45-2.11At least two exits remote from each other shall be provided from each floor, tier, room or balcony in structures which house amusement devices and which are not places of public assembly. No exit shall be less that eighteen inches wide.
6/1/2017 All amusement devices shall have two gates for entry and exit.45-2.13(a)(1)
45-2.13(a)(1)Safe and adequate means to access to and egress from amusement devices and temporary structures shall be provided. Such means of access and egress shall have protection from adjacent hazards or from falling by the use of rails, enclosures, barriers or similar means.
6/1/2017 Install a coverplate over the electrical outlet at the center hub.45-2.21(a)
45-2.21(a)General requirement. All electrical wiring, equipment and apparatus used for amusement devices or for lighting shall be installed, operated and maintained in compliance with this Part (rule), Industrial Code Rule 57 High Voltage Proximity, and the National Fire Protection, National Electrical Code, NFPA 70-1999 (NEC-1999).
6/1/2017 Install a metal Identification plate on the device with the serial number, name, no of passengers, max speed, in a visible location.45-2.5(a)
45-2.5(a)Every amusement device shall be identified by a trade or descriptive name and an identification number. A metal plate upon which there is legibly impressed the name and number of the device, its model number if any and the name and address of its manufacturer shall be firmly attached to the device in a readily visible location. The maximum safe number of passengers and the maximum safe speed, where applicable, shall be legibly impressed on the same plate or another metal place.
6/1/2017 Number each passenger compartment.45-2.5(b)
45-2.5(b)Each passenger carrying car, seat etc. in an amusement device or temporary structure shall be identified with an identification number in a readily visible location.

View All Events Listing

Thanks for the feedback! It will help us improve your experience.