Skip to Content Skip to Navigation

Amusement Device Detials

The New York State Department of Labor inspects all amusement devices on or before the scheduled start date of an event. Only those devices deemed safe are allowed to operate. Detailed inspection results for each individual device will be posted within two weeks of the event start date.

For more information, look at our Frequently Asked Questions.

Details for device: Quad Jump Euro-Bungee

Violation Summary

Violations Issued This Season: 5 Violations Complied at Time of Inspection: 4
Quad Jump Euro-Bungee Violations
Date Cited Description Violation
7/6/2017 Tighten the threaded connectors in the center just above the knuckle for the short wire ropes. COMPLIED AT VISIT45-1.6(b)
45-1.6(b)Assembly work shall be performed in a proper and workmanlike manner. Parts shall be properly aligned, and shall not be bent, distorted, cut or otherwise injured to force a fit. Parts requiring lubrication shall be lubricated in course of assembly. Fastening and locking devices, such as bolts, cap screws, cotter pins, lock washers, etc. shall be installed where required. Nuts shall be drawn tight, cotter pins shall be spread and lock nuts firmly set.
7/6/2017 Replace the worn out blue bungee for the right side of the harness on the blue set up. COMPLIED AT VISIT45-1.6(c)
45-1.6(c)Parts which are excessively worn or which have been materially damaged shall not be used. Close visual inspection of parts shall be made during assembly to discover such wear or damage and immediate inspection of fastening devices shall be made after assembly to assure that they have been properly installed.
7/6/2017 Replace the single pin with a double pin connector were it goes from the rope to the bungees. So it is uniform with the rest of the connectors. On the right side of the harness for the blue set up. Marked with a orange flag.45-1.6(c)
45-1.6(c)Parts which are excessively worn or which have been materially damaged shall not be used. Close visual inspection of parts shall be made during assembly to discover such wear or damage and immediate inspection of fastening devices shall be made after assembly to assure that they have been properly installed.
8/9/2017 Replace 2 sprung caribeaners with orange tape. Complied at visit45-1.6(c)
45-1.6(c)Parts which are excessively worn or which have been materially damaged shall not be used. Close visual inspection of parts shall be made during assembly to discover such wear or damage and immediate inspection of fastening devices shall be made after assembly to assure that they have been properly installed.
8/9/2017 Properly weld the crack at the top of wall on frame right in the middle at shown to Phil. Complied at visit45-1.6(c)
45-1.6(c)Parts which are excessively worn or which have been materially damaged shall not be used. Close visual inspection of parts shall be made during assembly to discover such wear or damage and immediate inspection of fastening devices shall be made after assembly to assure that they have been properly installed.
7/6/2017 Repair / replace the center motor that goes to the Red set up. Its missing the ground plug. This motor is marked with a white (X) on top. COMPLIED AT VISIT. They replace this motor with another one.45-2.21(a)
45-2.21(a)General requirement. All electrical wiring, equipment and apparatus used for amusement devices or for lighting shall be installed, operated and maintained in compliance with this Part (rule), Industrial Code Rule 57 High Voltage Proximity, and the National Fire Protection, National Electrical Code, NFPA 70-1999 (NEC-1999).

View All Events Listing

Thanks for the feedback! It will help us improve your experience.