Skip to Content Skip to Navigation

Amusement Device Detials

The New York State Department of Labor inspects all amusement devices on or before the scheduled start date of an event. Only those devices deemed safe are allowed to operate. Detailed inspection results for each individual device will be posted within two weeks of the event start date.

For more information, look at our Frequently Asked Questions.

Details for device: Tilt-A-Whirl

Violation Summary

Violations Issued This Season: 2 Violations Complied at Time of Inspection: 1
Tilt-A-Whirl Violations
Date Cited Description Violation
8/24/2017 Replace the connection cotter pins in the tub of the ride each time the ride is set up with new ones. COMPLIED AT VISIT45-1.6(b)
45-1.6(b)Assembly work shall be performed in a proper and workmanlike manner. Parts shall be properly aligned, and shall not be bent, distorted, cut or otherwise injured to force a fit. Parts requiring lubrication shall be lubricated in course of assembly. Fastening and locking devices, such as bolts, cap screws, cotter pins, lock washers, etc. shall be installed where required. Nuts shall be drawn tight, cotter pins shall be spread and lock nuts firmly set.
8/24/2017 Repair the crack in the top step on the entrance side of stairs to the ride.45-2.13(c)
45-2.13(c)Stairways and ramps shall be at least 18 inches wide. Stair treads shall be at least nine inches deep exclusive of nosing and the height of rise shall not exceed eight inches. Between any two levels the treads shall be of uniform depth and the risers of uniform height. The slope of ramps shall not exceed one in four. The open sides of stairways, ramps and platforms shall be provided with adequate protection against falling, except as the safe and normal access to the device may otherwise require.

View All Events Listing

Thanks for the feedback! It will help us improve your experience.