The New York State Department of Labor inspects all amusement devices on or before the scheduled start date of an event. Only those devices deemed safe are allowed to operate. Detailed inspection results for each individual device will be posted within two weeks of the event start date.
For more information, look at our Frequently Asked Questions.
|6/23/2017||The staff did not tighten the jam nuts on the center hub section attached to tub #2. Repaired after mentioned.||45-1.6(b)|
45-1.6(b)Assembly work shall be performed in a proper and workmanlike manner. Parts shall be properly aligned, and shall not be bent, distorted, cut or otherwise injured to force a fit. Parts requiring lubrication shall be lubricated in course of assembly. Fastening and locking devices, such as bolts, cap screws, cotter pins, lock washers, etc. shall be installed where required. Nuts shall be drawn tight, cotter pins shall be spread and lock nuts firmly set.
|7/3/2017||Reattach loose rear light on the back of seat #10 Complied at visit||45-1.6(c)|
|7/3/2017||Reattach loose rear light on the back of seat #7 Complied at visit||45-1.6(c)|
|7/11/2017||Tighten the loose tail light on the back of car #10. COMPLIED AT VISIT||45-1.6(c)|
|7/11/2017||Tighten the loose tail light on the back of car #7. COMPLIED AT VISIT||45-1.6(c)|
|5/18/2017||Install missing screw and washer in the inside seat section of tub #4. Complied at visit||45-1.6(c)|
Thanks for the feedback! It will help us improve your experience.